Bolting your SpiderPro Holster to a SpiderPro Belt

Step 1: use a 3/32 hex driver and remove the bottom two screws as shown in the image below.

Step 2: clip on the Spider onto the belt–make sure the two holes in the belt align with the bottom “L” gaps in the Stainless Clip.

Step 3: insert and screw in the two screws provided through the metal washers (the washers are optional) using a phillips head driver.

  • If using washers, make sure they sit under the Holster’s back clip.
  • Make sure to apply force so that the screw threads into the back of the Spider
    you will have to push the screws rather hard and bend the belt to accomplish this. It may help to place the belt on a table while doing this.
  • If you’re having trouble threading the screws try angling them slightly inward.

Step 4: make sure that the screws are threaded into the Spider base and are tightly pulling the base to the belt — the belt pad should be bent a bit to reflect that.

Step 5: check the back to make sure that the screws are in and are not loose in any way.

That’s it!

Menu